Project Book

Link to Book

Videos

Thanks to Hemi for directing, starring in, and editing these videos.

An overview of the vehicle:

RISD Human Powered Vehicle 2009 from Mike Eng on Vimeo.

And the "making of":

RISD Human Powered Vehicle 2009 - The Making of from Mike Eng on Vimeo.

FOR MORE PICTURES...

In case you want to see more pictures than shown on the blog just click on the picture below and you will be guided to our picasa web album. Enjoy some unpublished material!

SOME MORE DETAILS

THE PRESENTATION

Tuesday 19th of May, 1.30pm. The time has come to present the bike to our critic and the public.

THE FINAL ASSEMBLY

Only a few hours before the final presentation we could finally assemble the whole bike.

THE FINAL COAT

After having achieved a rigid enough body it was time to put on the final layer of carbon fibre. The difficiculty was to produce a nearly seemless coat.

ASSEMBLING THE DRIVE TRAIN

Assembling the drivetrain inside of the frame was definitely one of the most tense moments - taking all of our custom machined components and putting them to the ultimate test. We tested the fit of the components together and made sure nothing was rubbing on the inside of the frame. Though the assembly operation required a Leatherman, allen wrenches, and several improvised hooks, we were able to put everything together fine. The fit of the parts erred on the side of too tight. Only a couple of points inside the frame had to be sanded away to allow the chain to clear.

FIRST ROUGH ASSEMLBY

Having the frame, the front fork and the spoked wheels we could roughly assemble the parts and get a gasp of how the actual bike will look. A very exciting moment!

THE FRONT FORK

A lot of discussions took place about the design of the front fork, but no it´s finally done.

THE SEAT

Krisa spent a lot of time working on the seat and it´s starting to pay off. Completly made out of carbon fibre, it will be an important touchpoint between the rider and the bike. Especially with our concept with the crank before the saddle it is important that the seat offers enough back support.

SANDING, LAYING, SANDING, LAYING....

To get enough stiffness and stability in the frame we have to lay layer over layer and do in between lots and lots of sanding.

Components, components, components

Mike's setup for the crown - it is cut off-center in order to achieve a press fit with the crown race.

Hemi, the lathe master. 

Nick, the machinist machine.

Nick's setup with a custom jig in order to drill accurately into the airfoil tubing for the fork.

Adrian cleaning components in our clean room before setting them in the carbon fiber. Not pictured - the rest of the team standing around in haz-mat suits.

DRYING PROCESS

For a faster drying process we built a very rough but functioning case with a heating lamp around the modell.

LAYING CARBON FIBRE

After long time of preparation we finally have all the parts together and can start laying the carbon fibre. In a first round we secured all our hardpoints around the drive train by setting up the machined parts and laying the carbon fibre around these points.

SETTING UP THE JIG

Having finished the machinig and the pink foam modell we started setting up the jig. All the collected informations from the prototype and the real size drawing are coming together now.

PINK FOAM MODELL

Parallel to the machining we started working on the pink foam model, which will be the base for the laying of the carbon fibre.

The first rough cut and the stencil.

The final shape.

The intermediate hub will be placed in here.

SOME IMPRESSIONS OF THE HARD WORKING STUDENTS

NEW DESIGN

After locating the new position of the transfer hub, we had to come up with a new design. Biggest change is the drastic shortening of the rear fork and enlongment of the actual body. Further on, based on the new location of the transfer hub we had to relocate the saddle and integrated him into the body.